Kenwood TK-5810 Service Manual

Also see for FleetSync TK-5810(H): Instruction manual Specifications Service manual Instruction manual

TK-5810 (BG) /5810H (BG)13KCH-14GRPVOL CHPOWERTX BUSYPF1 PF2 PF3 PF4 PF5KCH-15GRPPOWERTXVOL CHBUSYSCAN OPT OSTA B CMONCALL SPMONSCNPF1 PF2 PF3 PF4 PF5PF9PF8PF7PF6Fig. 1-3Fig. 1-4 Keytop insertionFig. 1-5 Keytop removal2. Remote kit (KRK-5: Option)The KRK-5 remote kit is used to remotely operate thetransceiver. The KRK-5 is connected to the KCH-14 or KCH-15 with an optional KCT-22M (8 feet), KCT-22M2 (17 feet),or KCT-22M3 (25 feet) control cable.2-1. Installing the KRK-5 main panel onto thetransceiver1. Remove the upper case and lower case of the transceiv-er.2. Insert the lead wire with connector (W700) of the controlunit (X53-440) into the connector (CN4) of the KRK-5.3. Install the KRK-5 main panel on the transceiver usingfour screws q.Note:Take care that the lead wire with connector (W700) is notcaught when fitting the KRK-5 main panel on the trans-ceiver.4. Affixing the sheet (G11-4379-04) for the waterproof(Fig.2-1-2).(1) Remove the covering paper of the sheet w.(2) Affix the sheet while taking note of the position of thethree parts as shown in Fig.2-1-2 e.Firmly affix the sheet to the chassis by pushing thedouble-coated tape with your fingers.(3) Repeat step (2) to affix the sheet to the other side ofchassis.Note:The sheet cannot be reused. Affix a new sheet whenyou removed the sheet.5. Reassemble the upper case and lower case of the trans-ceiver. (Refer to page 18)Note:Take care that the sheet (G11-4379-04) is not peeled offwhen installing the upper/lower case.TransceiverPackingW700CN4KRK-5 main panel::Fig. 2-1-1INSTALLATION