Kenwood TK-5810 Service Manual

Also see for FleetSync TK-5810(H): Instruction manual Specifications Service manual Instruction manual

TK-5810 (BG) /5810H (BG)8REALIGNMENT11. Clone ModeProgramming data can be transferred from one trans-ceiver to another by connecting them via their microphonejacks. The operation is as follows (the transmit transceiveris the source and the receive transceiver is a target).The following data cannot be cloned.• Tuning data• Embedded message with password• Model name data• ESN (Electronic Serial Number) data• Network file data (P25)Key guide on the “INPUT PASSWORD” display.1. Press and hold the [PF5] key while turning the trans-ceiver power ON. If the Read authorization password isset to the transceiver, the transceiver displays “CLONELOCK”. If the password is not set, the transceiver dis-plays “CLONE MODE”.2. When you enter the correct password, and “CLONEMODE” is displayed, the transceiver can be used as thecloning source. The following describes how to enterthe read authorization password.3.• How to enter the read authorization password usingthe microphone keypad;If one of keys 0 to 9 is pressed while “CLONE LOCK” isdisplayed, the pressed number is displayed on the LCD.Each press of the key shifts the display in order to theleft.If you press the [#] key, the least digit of the password isdeleted.When you enter the password and press the [ ] key,“CLONE MODE” is displayed if the entered password iscorrect. If the password is incorrect, “CLONE LOCK” isredisplayed.• How to enter the read authorization password usingthe [Selector] knob;If the [Selector] knob is rotated while “CLONE LOCK”is displayed, the number (0 to 9) flashes on the LCD.When you press the [GRP ] key, the currently selectednumber is determined. If you press the [PF3] key, theleast digit of the password is deleted. If you press the[PF2] key after entering the password in this procedure,“CLONE MODE” is displayed if the entered password iscorrect. If the password is incorrect, “CLONE LOCK” isredisplayed.4. Power ON the target transceiver.5. Connect the cloning cable (part No. E30-3370-05) to themicrophone jacks on the source and target.6. Press the [PF2] key on the source while the source dis-plays “CLONE MODE”. The data of the source is sent tothe target. While the target is receiving the data, “PRO-GRAM” is displayed. When cloning of data is completed,the source displays “END”, and the target automaticallyoperates in the User mode. The target can then be oper-ated by the same program as the source.7. The other target can be continuously cloned. Whenthe [PF2] key on the source is pressed while the sourcedisplays “END”, the source displays “CLONE MODE”.Carry out the operation in step 4 to 6.Note:• You cannot clone transceivers using hardware versions1.0 or 2.0.Cloning is only possible when both transceivers are us-ing hardware version 3.0.• Cannot be cloned if the overwrite password is pro-grammed to the target.• “Model Name and Market Code”, “Head Configuration”and “Head Type” must be same to clone the transceiver.However, it may be unable to clone the transceiver de-pending on the enhanced features settings.(Refer to the FPU for the enhanced features details.)• Under certain conditions, clone mode cannot be acti-vated even if the clone mode of the source transceiver,using Hardware Version 3.0, is set to enable. Refer tothe FPU for more details.• Can not clone if the checksum in the Network File areaof the source transceiver and the target transceiver is dif-ferent.Cloning cable(E30-3370-05)