Kenwood TK-5810 Service Manual

Also see for FleetSync TK-5810(H): Instruction manual Specifications Service manual Instruction manual

TK-5810 (BG) /5810H (BG)153. Dual Control Head Remote Kit(KRK-6DH: Option)The KRK-6DH remote kit connects two displays (twoKCH-14s or KCH-15s) to the transceiver. The KRK-6DH isconnected to the KCH-14s or KCH-15s with two optionalcontrol cables. There are three version of the control cable:KCT-22M (8 feet), KCT-22M2 (17 feet), and KCT-22M3 (25feet).3-1. Installing the KRK-6DH main panel onto thetransceiver1. Remove the upper case and lower case of the transceiv-er.2. Insert the lead wire with connector (W700) of the controlunit (X53-440) into the connector (CN4) of the KRK-6DH.Insert the lead wire with connector (W104) of the KRK-6DH into the connector (CN503) of the transceiver.3. Install the KRK-6DH main panel on the transceiver usingfour screws q.Note:Take care that the lead wire with connector (W700) isnot caught when fitting the KRK-6DH main panel on thetransceiver.4. Affixing the sheet (G11-4379-04) for the waterproof(Fig.3-1-2).(1) Remove the covering paper of the sheet w.(2) Affix the sheet while taking note of the position of thethree parts as shown in Fig.3-1-2 e.Firmly affix the sheet to the chassis by pushing thedouble-coated tape with your fingers.(3) Repeat step (2) to affix the sheet to the other side ofchassis.Note:The sheet cannot be reused. Affix a new sheet whenyou removed the sheet.5. Reassemble the upper case and lower case of the trans-ceiver. (Refer to page 18)Note:Take care that the sheet (G11-4379-04) is not peeled offwhen installing the upper/lower case.KRK-6DHmain panelW700CN4CN5W104CN503Transceiver::Fig. 3-1-1Affix the sheet whiletaking note of the positionof the three parts.KRK-6DH main panel@.Fig. 3-1-23-2. Installing two KRK-6DH rear panels onto twofront panel kitsInstall each KRK-6DH rear panel onto each front panelkit as same as “2-2.Install the KRK-5 rear panel onto thefront panel kit” described on page 14.3-3. Control cable (KCT-22) connection (Fig. 3-2)1. Use two control cables. Insert one connector of the onecontrol cable to the transceiver (with KRK-6DH) and theother to the display 1.Insert one connector of the other control cable to thetransceiver (with KRK-6DH) and the other to the display 2.Connect each cable to the GND terminal with the screwsq supplied with each control cable.2. Secure the one connector of each control cable to theKRK-6DH main panel with two screws w according tothe installation condition of the transceiver. Pass the con-trol cables through the grooves at both ends of the KRK-6DH main panel and secure the control cables to theKRK-6DH with the cable fitting (J21-4354-04) and twoscrews e supplied with the KRK-6DH.3. Secure the other connectors of the control cables to thedisplay 1 and display 2 with two screws r in the sameway.INSTALLATION