TK-5810 (BG) /5810H (BG)20DISASSEMBLY FOR REPAIR2=.@::: ::@@@@::@;B>@Final unitTX-RXunitCN151CN200CN601CN600ControlunitCN1228 2 2 2 Disassembly Procedure (TK-5810(BG))■ Removing the upper/lower case and shielding cover1. Remove the 9 screws q and 9 spacers w.2. Remove the upper case e and lower case r.3. Remove the upper packing t and lower packing y.4. Remove the shielding cover u.■ Removing the TX-RX unit (X57-727)1. Remove the 7 screws i holding the PLL shielding cover.2. Remove the PLL shielding cover o.3. Remove the coaxial cables from the two connectors(CN151 and CN200) of the TX-RX unit !0.4. Remove the flat cables from the two connectors (CN600and CN601) of the TX-RX unit !1.Note:When re-installing the flat cable to the connector on theCN600 side, do not align the cable as shown in the figure1, as there is a possibility of producing an effect on thesensitivity of P25.5. Remove the 5 screws !2.■ Removing the Final unit (X45-379)1. Remove the cables from the connector (CN1) of the con-trol unit !3.2. Remove the 2 screws !4 holding the power module.3. Remove the solder of the power module with a solderabsorber.4. Remove the 2 screws !5 holding the + (positive) terminaland – (negative) terminal of the power supply cable.5. Remove the 8 screws !6 holding the final unit.6. Remove the solder of the antenna receptacle with a sol-der absorber.WrongRightCN600CN600