Kenwood TK-7180H Service Manual

Also see for TK-7180(H): Brochure & specs Specification Instruction manual Brochure & specs Instruction manual

Contents

TK-7180H/7182H9INSTALLATION1. Ignition Sense Cable (KCT-46 : Option)The KCT-46 is an optional cable for enabling the ignitionfunction. The ignition function lets you turn the power to thetransceiver on and off with the car ignition key.1-1. Connecting the KCT-46 cable to the transceiver1. Open the KCT-46 fuse holder and insert a mini blade fuse(3A). ( q )2. While holding a clear protective cover, remove the blackcap at the end of the yellow cable (ignition sense cable) ofthe transceiver. ( w )3. Connect the plug of the KCT-46 to the yellow cable termi-nal of the transceiver. ( e )4. Connect the other end of the KCT-46 to the ignition line ofthe car. ( r )Note : You must setup using the KPG-89D.qwer Iginition lineof the carF52-0019-05Fig. 12. Radio Interface Cable (KCT-40 : Option)The KCT-40 connection cable kit is used to connect thetransceiver to the KDS-100 (Mobile data terminal), KGP-2A(Modem GPS receiver), KGP-2B (Modem GPS controller) orthrough the KCT-36 extension cable.2-1. Connecting the KCT-40 cable to the transceiver1. Remove the D-sub cap on the rear of the transceiver. ( q )2. Connect the D-sub connector of the KCT-40 to the D-sub25-pin terminal of the transceiver. ( w )3. Connect the 15-pin connector of the KCT-40 to a KDS-100,KGP-2A, KGP-2B or through a KCT-36 extension cable.( e )Note : You must setup using the KPG-89D.KDS-100, KGP-2A,KGP-2B or throughKCT-36 extension cableqewFig. 22-2. Terminal functionD-sub 25-pin TK-7180H/7182H Molex 15-pin KDS-100 KGP-2A/2BPin No. Function Pin No. Function Function1 - - - -2 - - - -3 - - - -4 - - - -5 DI 5 DO DO6 - - - -7 GND 3 GND GND8 AIO8 9 TXS/LOK TXS/LOK9 TXD2 15 RXD RXD10 RXD2 14 TXD TXD11 - - - -12 AIO7 11 MM MM13 AIO6 6 PTT PTT14 SB 1 SB SB15 - - - -16 - - - -17 - - - -18 - - - -19 DEO 4 DI DI20 AIO5 8 SQ SQ21 AIO4 10 AM AM22 AIO3 13 - DISP OFF23 AIO2 12 - -24 AIO1 7 DTC DTC25 - - - -