TK-7180H/7182H11INSTALLATION4. Control Head Remote Kit(KRK-10 : Option) (TK-7180H only)The KRK-10 remote kit is used to remotely operate thetransceiver.4-1. Installing the KRK-10 kit to the transceiver1. Remove the front panel from the transceiver.2. Install the KRK-10 main panel onto the transceiver.3. Install the KRK-10 rear panel onto the front panel.4. Connect the KRK-10 main panel to the rear panel with thecable.■ Remove the front panel from the transceiver1. Lift the two tabs of the panel on the bottom of the trans-ceiver with a flat-head screwdriver ( q ) and remove thepanel from the chassis ( w ).Note : Confirm that the tabs of the speaker hardware fix-ture and holder is securely fitted in the front panel.2. Remove the flat cable from the connector (CN902) of thedisplay unit of the panel. ( e )3. Fold the black line of the flat cable (in three parts) asshown in Figure 4-2. ( r, t, y )■ Install the KRK-10 main panel onto the transceiver4. Insert the flat cable that was removed in step 2 above intothe connector (CN1) of the interface unit (A/2) of the KRK-10 main panel (A62-1101-01). ( u )Note : The terminal side of the flat cable must face downwhen inserting the flat cable into the connector.5. Fit the main panel with four tabs onto the front of thechassis. ( i )Note : When installing the main panel onto the front of thechassis, hold down the flat cable with your fingers to pre-vent it from being caught.■ Install the KRK-10 rear panel onto the front panel6. Insert the flat cable attached to the interface unit (B/2) ofthe KRK-10 rear panel (A82-0056-11) into the connector(CN902) of the display unit of the panel ( o ). (The flatcable has been pre-inserted in the connector (CN2) of therear panel at the time of shipping.)Note : The terminal side of the flat cable must face downwhen inserting the flat cable into the connector.7. Fit the four tabs of the rear panel into the front panel. ( !0 )CN902CN2 KRK-10 rear panel!0oCN1KRK-10 main paneluiCN902qwertyyrtChassissidePanelsideFig. 4-1Fig. 4-2Fig. 4-3Fig. 4-4