Kenwood TK-7180H Service Manual

Also see for TK-7180(H): Brochure & specs Specification Instruction manual Brochure & specs Instruction manual

Contents

TK-7180H/7182H12INSTALLATION■ Connect the KRK-10 main panel to the rear panelwith the cable8. Insert one 14-pin connector of the cable (E30-7514-15)into the connector (CN3) of the interface unit (A/2) of themain panel. ( !1 )Note : Insert the connector that has a sticker onto thecable to the connector of the main panel.9. Secure the cable bush on the main panel and fit the water-proof packing (orange) ( !2 ) securely over top.10. Install the molded cover ( !3 ) over the connector on themain panel and secure it with two screws ( !4 ).11. Insert the other 14-pin connector of the cable into theconnector (CN4) of the interface unit (B/2) of the rearpanel. ( !5 )12. Secure the cable bush on the rear panel and fit the water-proof packing (orange) ( !6 ) securely over top.13. Install the molded cover ( !7 ) over the connector on therear panel and secure it with two screws ( !8 ).Note : A cable can be connected from the left side as shownin the Figure 4-5 or from right side.However, the 14-pin connector must be connected to correctdirection.5. Voice Guide & Storage Unit(VGS-1 : Option) (TK-7180H only)5-1. Installing the VGS-1 unit in the transceiver1. Remove the cabinet, top packing and shielding plate of thetransceiver.2. Attach two cushions to VGS-1 as shown in Figure 5. ( q )Note : Be sure not to cover the connector with the bottomcushion.3. Insert the VGS-1 connector (CN1) into the TX-RX unit (B/3)connector (CN403). ( w )Note : You must setup using the KPG-89D.CN4CN3!8 !8!7!6!5!2!2!3!4!4!1(Right side)KRK-10rear panelKRK-10main panelStickerStickerFig. 4-5CN1CN403qwCushion(G13-1994-04)20 x 30 x 12 mmCushion(G13-1992-04)21 x 21 x 2.5 mmVGS-1Fig. 5