Kenwood TM-241A Instruction Manual

Also see for TM-241A: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

5-10-1 Paging Code Memories 4. Press the DR/DT key. The first digit will flash.(Not necessary this operation if you use DTMFThere are five(5) paging code memories. microphone)UsePA Store your individual ID code in memory.PO Automatically stores the calling station'scode during reception. Can temporarily |set code for the station. 1P1~pPp3 | Stores group codes and local station 5. Set the desired number with the tuning contro! andcodes in memory. press the DR/DT key (or key 0 to 9 on the microphonewith DTMF). The first digit will be set, and the5-10-2 Setting the Paging Codes second digit will flash.1. Press the DR/DT key to enter the paging mode. The Pindicator will light.2. Press the F key, then press the DR/DT key while the Findicator is on. The code setting mode will beentered and the memory channel indicator will flash.6. Set the second and third digits with the tuningcontrol, and press the DR/DT key.@er WeEcycr } 7. If, after 10 seconds, no key has been pressed, or a keyother than DR/DT or MR/M is pressed, the code will3. Set the desired memory (0 to 3 or A) with the tuning be set.control (or key 0 to 3 or A on the microphone [op-tion] with DTMF).42