Kenwood TM-D700A Instruction Manual

Also see for TM-D700A: Instruction manual Operation instruction Service manual

134n Setting UTC Offset1 Press [MNU] to enter Menu mode.2 Press [ccccc]/ [ddddd] to select “RADIO (1–)”, then press[OK].3 Press [ccccc]/ [ddddd] to select “TNC (1–6–)”, then press[OK].4 Select Menu 1–6–5 (TIME ZONE), then press[OK].5 Press [ccccc]/ [ddddd] to select the appropriate UTCoffset, then press [OK].• The selectable range is from +12:00 to –12:00 insteps of 30 minutes.6 Press [MNU] to exit Menu mode.SELECTING DATA BANDOn this transceiver you can select data band for APRSmode independent of the selection (in Menu 1–6–1) forPacket mode. Access Menu 3–I (DATA BAND) andselect band A or B as the data band for receiving ortransmitting APRS packets. The default is band A. “ ”indicates the current data band.Note: In Menu 3–I, the selection switches among A, B, A:TX B:RX, andA:RX B:TX. Select A:TX B:RX or A:RX B:TX if APRS networks which usetwo separate frequencies become available in the future.SELECTING PACKET TRANSFER RATEThe default APRS packet transfer rate set on the built-inTNC is 1200 bps which is the standard among thecurrent APRS networks. If APRS networks which use9600 bps transfer rate become available in the future,access Menu 3–J (PACKET SPEED) and select “9600bps”.