Kenwood TM-D710E Instruction Manual

Also see for TM-D710A: Instruction manual Instruction manual Product manual Manual Service manual

Contents

PACKET-5Command Name Short Description Parameter DefaultKISS KISS When ON, entering a RESTART command causes theTNC to enter (or exit) KISS mode. ON/ OFF OFFLCSTREAM LCSWhen ON, changes a small letter (a through z) enteredas a stream designator, to a capital letter (A throughZ). A stream designator must be entered immediatelyafter STREAMSW.ON/ OFF ONLIST LI Displays the list of messages, in the TNC mailbox,other than those addressed to other stations. − −LOCATION LOCIf set to EVERY, sends GPS data at intervals of thespecified period (n). If set to AFTER, sends GPS dataonly once after the specified period (n). The unit of nis 10 seconds.EVERY/ AFTERn(n = 0 ~ 250)EVERY 0LOG LOG Displays the list of stations which have connected tothe TNC mailbox. − −LPATH LPASpecifies callsigns to send GPS data. Call1 is thecallsign of the destination. Call2 to call9 are callsignsof stations to be digipeated through.Call1 (VIA call2,call3, ... call9) GPSLTEXT LT Specifies the content of a message to be included inGPS data.0 ~ 159characters −LTMON LTMSpecifies the interval for displaying a messagedetermined by LTEXT on the screen; a messageappears like a received beacon packet. The unit of theparameter is 1 second.0 ~ 250 0MAIL MAIWhen ON and the TNC mailbox holds a messageaddressed to you, outputs “Low” to the MAILLEDterminal.ON/ OFF OFFMAXFRAME MAX Specifies the maximum number of packets to betransmitted at one time. 1 ~ 7 4MBOD MB When ON, allows the TNC mailbox to be used. ON/ OFF OFFMCOM MCOMWhen ON, causes the TNC to also monitor controlpackets. When OFF, causes it to monitor onlyinformation packets.ON/ OFF OFFMCON MC When ON, causes the TNC to monitor other stationswhile in connection with the target station. ON/ OFF OFFMINE MI Displays the list of messages, in the TNC mailbox,addressed to you and messages that you sent. − −MONITOR M When ON, causes the TNC to monitor packets. ON/ OFF ONMRPT MR When ON, causes the TNC to display the entiredigipeat list for monitored packets. ON/ OFF ONMSTAMP MS When ON, causes the TNC to display data and timeinformation for monitored packets. ON/ OFF OFFMYALIAS MYA Specifies a callsign for using your station as adigipeater.6 characters +SSID −MYCALL MY Specifies your callsign. 6 characters +SSID −MYMCALL MYM Specifies a callsign to be assigned to your TNCmailbox.6 characters +SSID −NEWMODE NE When ON, entering a CONNECT command causesthe TNC to immediately enter the other mode. ON/ OFF OFFNOMODE NOWhen ON, does not cause the TNC to automaticallyenter the other mode. When OFF, causes it toautomatically enter the other mode as specified byNEWMODE.ON/ OFF OFF