Kenwood TM-D710E Instruction Manual

Also see for TM-D710A: Instruction manual Instruction manual Product manual Manual Service manual

Contents

APRS-4ACCESSING RECEIVED APRS DATAThis transceiver is capable of receiving and storing APRSdata received from up to 100 stations in memory. You caneasily recall the information of the desired station.1 Press [KEY], [LIST].• The list of stations appears.• The numbers beside the callsigns indicate the order in whichdata is received. The data received last is assigned 1.[TOP]: Displays the list of the fast 5 stations.[5↑]: Displays the list of the previous 5 stations.[5↓]: Displays the list of the next 5 stations.[ESC]: Restores the frequency display.[MSG]: Allows message entry to the current station.[SORT]: To select the sort function.[FILTER]: To select the filter function.[TUNE]: Set the QSY frequency (APRS only).[CLR]: Deletes the current station.• Press [F].[POS.RQ]: Request position.[ALLCLR]: Deletes all stations.• When you press [ALLCLR], “CLEAR ALL?” appears withthe message. Press the Tuning Control to clear all.2 Rotate the Tuning control to select the desired stationusing the cursor ( ).3 Press the Tuning control.• The information of the selected station appears.[BACK]: Restores the list of stations.[MSG]: Allows message entry to the current station.[←]: Displays the previous page.[→]: Displays the next page.[TUNE]: Set the QSY frequency (APRS only).[CLR]: Deletes the entire information of the currentstation.Note:◆ When data from the 101st station is received, the oldest data inmemory is replaced by that data.◆ Each time a new APRS packet is received from the same station,the old data from that station (in memory) is replaced by newdata.CURSOR CONTROLSelect a cursor control setting for reception.1 Display the station list.2 Press [TOP] to change the curser control betweenFollowed mode and Fixed mode. The cursor displaychanges according to the selected mode.Followed mode ( ): On the list screen, the cursor( ) follows the callsign when receiving APRS data.Fixed mode ( ): On the list screen, the cursor ( )sits at the list number when receiving APRS data.