Kenwood VR-4900 Connection And Setup Manual

Also see for KRF-V9993D: Service manual Service manual User guide How to operate Connection guide

Contents

23Chapter One : Connecting Your DevicesConnectionsConnecting Your Secondary CD Player or Tape Deck, continuedDo not plug in the receiver to AC power until you haveconnected all your devices.This section focuses on the connections from your CD playeror tape deck to the VR-4900/VR-4700/KRF-V9993D. Pleaserefer to your CD player or tape deck’s instructions for moredetail about its connection jacks and capabilities.Each set of instructions in this section shows one of severalpossible variations on connecting your CD player or tapedeck. For further assistance on optional configurations, con-tact the store where you purchased your CD player or tapedeck.Do not connect a system control cable from any unit con-nected via the CD2/TAPE2 MONITOR jacks.To Connect a Secondary CD Player:1. Connect the audio cables from the CD player’s audiojacks to the receiver’s CD2/TAPE2 MONITOR PLAY INjack set as shown to the left.Do not connect the system control cable from the sec-ond CD player, even if it supports system control.2. Go to “Noting Your Devices” on page␣ 3 and note whichjacks you used to connect your CD player. In addition,note the brand name and model number of the CDplayer.When you set up the PowerTouch remote to control yourdevices, be sure to follow the procedure under “What ifI Connected a CD Player to the Jack Set PowerTouchCalls Tape2?” on page␣ 38.If you connect a second tape deck, you cannot connect asecond CD player.To Connect a Secondary Tape Deck:1. Connect the audio cable from the tape deck’s Play OUTjacks to the receiver’s CD2/TAPE2 MONITOR PLAY INjacks.2. Connect the audio cable from the tape deck’s Rec INjacks to the receiver’s CD2/TAPE2 MONITOR REC OUTjacks.Do not connect the system control cable from the sec-ond tape deck, even if it supports system control.3. Go to “Noting Your Devices” on page␣ 3 and note whichjacks you used to connect your tape deck. In addition,note the brand name and model number of the tapedeck.If you connect a second CD player, you cannot connect asecond tape deck.