33Remote SetupChapter Two : Setting Up PowerTouchCalibrating the Touch ScreenAfter you install the batteries or reset PowerTouch, you needto calibrate the touch screen. The touch screen responds topressure from the included stylus or your finger:If you are replacing batteries and complete the battery re-placement within 3 minutes, you do not need to calibratethe screen; calibration is stored in memory.If the screen’s performance begins to change, you canrecalibrate it without resetting PowerTouch by pressingon the Setup Preference menu. For more informationabout accessing this menu, see “Identifying Devices ForPowerTouch Control” on page␣ 37.To calibrate the touch screen, use the stylus to touch the cen-ter of each of the calibration points displayed:When you touch each calibration point, you should hear abeep and see the next point, indicating that area of the screenis now calibrated. If you do not hear a beep, touch the cali-bration point until you do.The touch screen is sensitive to pressure, not to movement.Press firmly but gently on any touch screen element. The screenwill not respond if you simply brush the stylus or your fingeralong the surface.Resetting PowerTouchIf you want to reconfigure PowerTouch, you can reset it.You do not need to do this unless you experience a prob-lem.1. Open the cover.2. Use the stylus to press the blue button at the bottom ofthe battery case:The items you set up in this chapter will remain inPowerTouch. If you want to make it to the factory–set de-fault condition, please follow the instructions on page 98/99 of the Users’ Guide.Selecting the Model TypeIf you committed mistake in the model type selection, re-start it as follows.• While holding the CONFIRM and VOLUME DOWN keystogether, press and release the RESET button under thebattery cover (see above diagram). Do not release theCONFIRM and VOLUME DOWN keys until a short beepindicating the completion of setting is heard.After the above, all settings are reset to the factory set-tings.After “Calibrating the Touch Screen”, the “Selecting the ModelType” display appears automatically (Except for KRF-V9993D). (This is not displayed when the model type hasalready been set.)If you have this receiver...VR-4700KRF-V9993DMODEL 1VR-4900MODEL 2MODEL 3Use this modeltype...To set the model type:1. Press the receiver’s ON STANDBY key to turn it ON.2. Point the PowerTouch to the receiver and press thein the display.3. The receiver automatically transmits its type code toPowerTouch. When the PowerTouch stores it, the modeltype selection is complete.Now the new PowerTouch is available for operation. The“Quick Tour” is the initial display after the batteries havebeen loaded.• If the model type cannot be selected automatically be-cause the receiver is not ON, etc., the model type can beselected manually. In this case, refer to the table on theright and select the correct model type in step 2 above.RC-R1110:(For VR-4900/VR-4700)RC-R1010:(For KRF-V9993D)RESETRESET