Kenwood VR-606 VR-616 Instruction Manual

Also see for VR-606: Instruction manual Instruction manual Service manual Service manual

13 EN1 Strip coating. 2 Push the lever.3 Insert the cord. 4 Return the lever.Setting up the systemConnecting the terminalsSpeaker impedanceAfter confirming the speaker impedance indications printed on therear panel of the receiver, connect speakers with matching impedanceratings. Using speakers with a rated impedance other than thatindicated on the rear panel of the receiver could result in malfunctionsor damage to the speakers or receiver.• Never short circuit the + and – speaker cords.• If the left and right speakers are connected inversely or the speakercords are connected with reversed polarity, the sound will beunnatural with ambiguous acoustic imaging. Be sure to connect thespeakers correctly.Connecting the antennasAM loop antennaThe supplied loop antenna is for use indoors. Place it as far as possiblefrom the receiver, TV set, speaker cords and power cord, and adjustthe direction for best reception.FM indoor antennaThe supplied indoor antenna is for temporary use only. For stablesignal reception we recommend using an outdoor antenna. Disconnectthe indoor antenna when you connect one outdoors.FM outdoor antennaLead the 75Ω coaxial cable connected to the FM outdoor antenna intothe room and connect it to the FM 75Ω terminal.Use an antennaadaptor(Commerciallyavailable)Attach to the standAM loop antennaFM indoor antennaFM outdoor antennaSpeaker placementFront speakers : Place to the front left and right of the listeningposition. Front speakers are required for all surround modes.Center speaker : Place front and center. This speaker stabilizes thesound image and helps recreate sound motion. Required for surroundplayback.Surround speakers : Place to the direct left and right, or slightlybehind, the listening position at even heights, approximately 1 meterabove the ears of the listeners. These speakers recreate soundmotion and atmosphere. Required for surround playback.Subwoofer : Reproduces powerful deep bass sounds.• Although the ideal surround system consists of all the speakerslisted above, if you don't have a center speaker or a subwoofer, youcan divide those signals between the available speakers in thespeaker settings steps to obtain the best possible surroundreproduction from the speakers you have available. %FrontspeakerSubwooferSurroundspeakerCenter speakerListeningpositionAM antenna terminal connections1 Push lever. 2 Insert cord. 3 Release lever.FM antenna terminal connectionsInsert cord.S VIDEOVIDEO 2INDVDINMONITOROUTSUB WOOFERPRE OUTVIDEO 2COAXIALDVDDIGITAL INCD / DVDOPTICALVOLTAGESELECTORAC110V-120V / 220V-240V~50 / 60HzSWITCHEDTOTAL 90W MAX.AC OUTLETSAC 220-240V~AC 110-120V~SPEAKERSSURROUNDSPEAKERS(8-16Ω)CENTERSPEAKER(8-16Ω)FRONTSPEAKERS(8-16Ω)GRAYWHITE GREEN BLUEREDL CR LRCENTERSUBWOOFERSURROUNDFRONTDVD / 6CH INPUTPLAY INVIDEO 2AUDIOREC OUT PLAY INVIDEO1PHONO REC OUT PLAY INMD / TAPECD / DVDLRVIDEO 1OUTVIDEO 1INVIDEOVIDEO 2INDVDINMONITOROUTANTENNAGNDAMFM75ΩSYSTEMCONTROL+-+-ANTENNAGNDAMFM75Ω