Kenwood VR-606 VR-616 Instruction Manual

Also see for VR-606: Instruction manual Instruction manual Service manual Service manual

25 ENDVD 6-channel playbackUsing a DVD player or the like equipped with six (5.1) output channels andthe receiver, you can enjoy surround sound playback.When you try to play a disc other than Dolby Digital such as DTS CD, nosound is produced or, noise may be heard. To avoid this situation, makesure that you connect the component to the receiver’s DVD/6CH INPUTjacks through a surround processor which can decode the surroundsignal you want to listen to.Connecting a DVD player which can decode the surround signal itself isalso acceptable.DVD/6CHINPUT SELECTORINPUT MODEINPUT MODEPreparations• Connect your DVD player to the DVD/6CH jacks of the receiver.• Turn on all other components that will be used.• Complete “Preparing for surround sound”. %1Select “DVD/6CH” as the input source.2Select "6CH INPT" by pressing the INPUT MODE key.3Start playback of the DVD software.4Adjust the volume.• It is not possible to adjust the volume level or sound quality (SET UP,SOUND) of the channels separately when the receiver is in theDVD/6CH mode. Adjust the volume with the controls of the DVDplayer.For the powered subwoofer, you can adjust the volume of thesubwoofer using the subwoofer’s own volume control.• ACTIVE EQ will not be available during DVD/6CH mode.Convenient functionsAdjusting the soundYou can make further adjustments to the sound while listening toplayback in the surround mode.1 Press the SOUND key until the desired item appears in thedisplay.Each time you press the button, the menu changes as follows:Note that some items are not displayed in certain modes.1 C (center speaker level adjustment)*2 SR (right surround speaker level adjustment)*3 SL (left surround speaker level adjustment)*4 SW (subwoofer level adjustment)*5 INPUT (input level adjustment - analog mode only) &6 NIGHT (midnight mode ON/OFF - Dolby Digital mode only)7 PANORAMA (Panorama mode ON/OFF)**8 DIMENSION (Dimension adjustment)**9 CENTER WIDTH (Center Width adjustment)*** The adjustment is only temporary for the current input selection.The value will return automatically to the original setup valuewhen the power is turned on/off or when the input selection ischanged.** Pro Logic II Music mode only.2 Use the MULTI CONTROL knob or Joystick to adjust the settingas desired.• The adjustment item is displayed for approximately 8 seconds.Ambience effectsMULTI CONTROLDIMMER SOUNDSOUNDLISTEN MODEJoystick(MULTICONTROL 5/∞)