Kenwood VRS-7100 Instruction Manual

Also see for VRS-7100: Service manual

Contents

28 ENPreparing for playbackInput level adjustment (analog sources only)If the input level of an analog source signal is too high, the "CLIP" indicatorwill lights up to indicate the source signal. Adjust the input level.1 Press the RCV Mode key on the remote control unit to setit to the receiver control mode.2 Press the Sound key.3 Use the MULTI CONTROL @ / # (or the Multi @ / # keys) toselect "INPUT", and press the ENTER (or the Enter key).4 Use the MULTI CONTROL % / fi (or the Multi % / fi keys)to adjust the input level.I N ) dTUP B÷ The adjustment mode is displayed for approximately 20seconds.÷ The input level may be adjusted to any one of three settings:0dB, -3dB, and -6dB. (The initial setting is 0dB.)÷ You can store a separate input level for each input selector.5 Press the Sound key again to return to the input indication.Re-assignment of rear panel jacksThe assignment of the input selector positions to the digital audio andcomponent video input jacks can be changed as desired.1 Press the SETUP key (or the Setup key).2 Use the MULTI CONTROL @ / # (or the Multi @ / # keys)to select "ASSIGN." on setup displays, and press theENTER (or the Enter key).3 Use the MULTI CONTROL @ / # (or Multi @ / # keys) toselect "DIGITAL" or "COMPONENT VIDEO", and pressthe ENTER (or the Enter key).1 "DIGITAL": Select to change the assignment of the digitalaudio input jacks of the receiver.2 "COMPONENT VIDEO"*: Select to change the assignmentof the component video input jacks of the receiver.3 "EXIT": Press the ENTER (or the Enter key) again toreturn to the main setup displays.* For U.S.A. and Canada only.Input selector position (%/fi)1 "DVD"2 "V2"3 "V1"4 "AUX"When the "DIGITAL" has been selected :Input selector position (%/fi)1 "DVD"2 "V2"3 "V1"Input jack selection (@/#)1 "CPNT1"2 "CPNT2"When the "COMPONENT" has been selected :(For U.S.A. and Canada only)Jack nameCOAX2 (VIDEO 2)OPT1 (VIDEO 1)OPT2 (AUX)COMPONENT VIDEO INPUTIN1 (DVD)COMPONENT VIDEO INPUTIN2 (VIDEO 2)COAX1 (DVD)4 Press MULTI CONTROL @/# (or the Multi @/# key) to selectthe input jack name and then press MULTI CONTROL % /fi(or the Multi % /fi key) to select the input selector position.C O D V1XA D÷ It is not permitted to assign two input selector positions forone input jack. In this case, you will have to assign differentinput selector positions again.5 Repeat step 4 until you have assigned the desired jacksto the desired input selector positions.6 Press the ENTER (or the Enter key) again to return to themain setup displays.Use the following table for your memorandum.Input jack Input selectorAssigned input selectorInput jack selection (@/#)1 "COAX1"2 "COAX2"3 "OPT1"4 "OPT2"