30 Getting Started GuideQuick-StartInstrument Safety & Environmental InformationAC power cordThe test set is equipped with a three-wire power cord, in accordance withinternational safety standards. This cable grounds the test set cabinet whenconnected to an appropriate power line outlet. The cable appropriate to theoriginal shipping location is included with the test set. See:http://www.keysight.com/find/powercordsEnvironmental Conditions (Operating)This product is designed for use in the following conditions:— For indoor use only— Temperature 5°C to 45°C— Altitude up to 3048 meters— 0% Relative Humidity to 90% Relative Humidity up to 40°C, and linearlydecreasing to 50% Relative Humidity up to 45°C; non-condensing.Always use the three-prong AC power cord supplied with this product. Failure toensure adequate earth grounding by not using this cord can cause productdamage.This instrument has auto-ranging line voltage input; be sure the supply voltageis within the specified range and voltage fluctuations do not to exceed 10percent of the nominal supply voltage:100/120 VAC 50/60 Hz, 1000 W MAX220/240 VAC 50/60 Hz, 1200 W MAX.If this product is not used as specified, the protection provided by theequipment could be impaired. This product must be used in a normal condition(in which all means for protection are intact) only.Install the instrument so that the detachable power cord is readily identifiableand easily reached by the operator. The detachable power cord is theinstrument disconnecting device. It disconnects the mains circuits from themains supply before other parts of the instrument. The front panel switch is onlya standby switch and is not a LINE switch. Alternatively, an externally installedswitch or circuit breaker (which is readily identifiable and is easily reached bythe operator) may be used as a disconnecting device.This product is designed for use in Installation Category II andPollution Degree 2.
