|
Getting Started Guide 85XSA InterfaceSwitched MIMOAcquisition RF Input PortAn RF input path must be selected for each acquisition. In the Meas Setup >Acquisition Setup > Acquisition RF Input Port menu, select RFIO1, RFIO2, orRF Input, as needed for each acquisition. The RF Input selection, which is usedfor the third port in 3x3 switched MIMO, means that whichever of thehalf-duplex ports (RF3 I|O or RF4 I|O) has been designated as the RF input isused (see “Half Duplex RF Input” on page 83). In SCPI, the acquisition RF inputport is controlled by the last parameter in the complex command whichconfigures the acquisition (the values for the relevant parameter are italicizedhere):[:SENSe]:LSEQuencer:ACQuire[1]|2|...|4..512:SETupNONE | GSM | EDGE | WCDMA | CDMA2K | CDMA1XEV | LTE | LTETDD |TDSCDMA | BTooth | WLAN,NONE | PGSM | EGSM | RGSM | DCS1800 | PCS1900 | TGSM810 | GSM450 |GSM480 | GSM850 | GSM700 | BANDI | BANDII | BANDIII | BANDIV |BANDV | BANDVI | BANDVII | BANDVIII | BANDIX | BANDX | BANDXI |BANDXII | BANDXIII | BANDXIV | USCELL | USPCS | JAPAN | KOREAN |NMT | IMT2K | UPPER | SECOND | PAMR400 | PAMR800 | IMTEXT |PCS1DOT9G | AWS | US2DOT5G | PUBLIC | LOWER | BAND1 | BAND2 | BAND3| BAND4 | BAND5 | BAND6 | BAND7 | BAND8 | BAND9 | BAND10 | BAND11 |BAND12 | BAND13 | BAND14 | BAND17 | BAND18 | BAND19 | BAND20 |BAND21 | BAND24 | BAND25 | BAND26 | BAND27 | BAND28 | BAND31 |BAND33 | BAND34 | BAND35 | BAND36 | BAND37 | BAND38 | BAND39 |BAND40 | BAND41 | BAND42 | BAND43 | BAND44 | BANDA | BANDB | BANDC| BANDD | BANDE | BANDF,BTS | MS,, , ,LOW | ZERO | HIGH,IMMediate | VIDeo | Video2 | INTernal | EXT1 | EXT2,, NONE | INT/,,OFF | RFIO0 | RFIO1 | RFIO2 | RFIO3 | RFIO4 | RFIO5 | RFIO6 |RFIO7,ON | OFF,NORMal | PRIMary | LOWer | UPPer | RANGe | SMIMo,RFIO1 | RFIO2 | RFIN | RFIO3 | RFIO4In the Acquisition RF Input Port parameter (italicized above),the values RFIO3 and RFIO4 apply only if the test set hasOption 4FD. The parameter immediately preceding that one isthe Acquisition Integration parameter, and can be set toPRIMary or SMIMo as needed (see “Acquisition Integration” onpage 84).
|
