52 Keysight EXG and MXG X-Series Signal Generators User’s GuideBasic OperationConfiguring a Swept Output13.As desired, repeat step 12 for the remaining points for which you want to select a waveform.The following figure shows an example of how this might look.14.Turn sweep on:Press Return > Return > Return > Sweep > Freq Off On > Amptd Off On > Waveform Off On.15.If it is not already on, turn the RF output on:Press RF On/Off.The SWEEP annunciator appears on the display, indicating that the signal generator issweeping, and the progress bar shows the progression of the sweep.Example: Using a Single Sweep1. Set up either a step sweep (page 48) or a list sweep (page 50).2. In the List/Sweep menu, set the sweep repeat to single:Press Sweep Repeat Single Cont to highlight Single.Sweep does not occur until you trigger it.Note that the WINIT annunciator appears on the display, indicating that the sweep is waitingto be initiated.3. If not already on, turn the RF output on: Press RF On/Off.4. Initiate the sweep: Press Single Sweep.A single repetition of the configured sweep is available at the RF Output connector.As the signal generator sweeps, the SWEEP annunciator replaces WINIT on the display, and theprogress bar shows the progression of the sweep.At the end of the sweep, there is no progress bar, and the WINIT annunciator replaces SWEEP.If the instrument is in manual sweep (page 53), the active row (row 6 in thefigure above) is the selected (manual) point, and the signal generatoroutputs the settings for that selection when the RF output is on.The empty entry is equivalent tochoosing CW (no modulation).
