Introduction 1U1461A/U1453A User’s Guide 45Analog bar graphThe analog bar emulates the needle on an analog tester, without displaying theovershoot.The “+” or “–” sign indicates whether the measured or calculated value is positiveor negative. Each bar represents 10 to 100 counts depending on the display countand range selected.See Table 1-7 for the relevant display counts, span, and counts per bar.% Percent, unit for duty cycle measurement°C Degree Celsius, unit for temperature measurement°F Degree Fahrenheit, unit for temperature measurementm, km Meter, units for lengthft Feet, unit for lengths Seconds, unit for Recording mode elapsed timeTable 1-6 Measurement units display (continued)Sign/Notation DescriptionNOTE For frequency, duty cycle, pulse wid th, 4-20 mA % scale, 0-20 mA % scale, andtemperature measurements, the bar graph does not represent the primarydisplay value.For example, when frequency, duty cycle, or pulse width is displayed on theprimary display during voltage or current measurement, the bar graphrepresents the voltage or current value (not the frequency, duty cycle, or pulsewidth value). Another example is when 4-20 mA % scale or 0-20 mA % scale isdisplayed on the primary display, the bar graph represents the current value andnot the percentage value.Figure 1-6 Analog bar graph example
