Keysight Technologies X Series Service Manual

Also see for X Series: Installation note Measurement guide Installation note Security Features and Document of Volatility User guide

Contents

Keysight Technologies X Series Service Manual Manual pdf 116 page image

116 Keysight N9010A EXA Service GuideInstrument MessagesCondition Errors 1 to 99, CalibrationCondition Errors 1 to 99, CalibrationCondition Errors 6 to 34, Calibration SkippedErrors with instrument internal alignment routines being skipped. (Selected tonot be executed.)An event with the error number shown in the table means the condition hasbeen detected.When the condition is cleared, an event with the error number plus 1000 isgenerated.For example, error 6 indicates that the RF Alignment not being done duringalignments has been detected, error 1006 indicates that failure has beencleared.An E in the Error or Warning column means that an error is put up on the frontpanel and sent out to SCPI when this condition is detected. A W in this columnmeans that a Warning is put up on the front panel but nothing goes out toSCPI. Nothing in this column means nothing is put up; status bit only.Err# Message Error orWarningVerbose/Correction Information6 Align RF Skipped W8 unused bit4 is set10 unused bit4 is set12 unused bit4 is set14 unused bit4 is set16 unused bit5 is set18 unused bit6 is set20 unused bit7 is set22 unused bit8 is set24 unused bit9 is set26 unused bit10 is set28 unused bit11 is set30 unused bit12 is set32 unused bit13 is set34 unused bit14 is set