Keysight N9010A EXA Service Guide 121Instrument MessagesCondition Errors 101 to 199, Measurement IntegrityCondition Errors 101 to 199, Measurement IntegrityErrors with making measurements: triggering, over range, badacquisition/data, bad settings.An event with the error number shown in the table means the condition hasbeen detected.When the condition is cleared, an event with the error number plus 1000 isgenerated.For example, error 129 indicates a Meas Uncal condition has been detected,error 1129 indicates that failure has been cleared.An E in the Error or Warning column means that an error is put up on the frontpanel and sent out to SCPI when this condition is detected. A W in this columnmeans that a Warning is put up on the front panel but nothing goes out toSCPI. Nothing in this column means nothing is put up; status bit only.Err# Message Error orWarningVerbose/Correction Information133 Signal Summary E135 No Result E135 No Result; Meas invalidwith I/Q inputsE The current measurement does not support I/Q input;switch to the RF or another input or select a differentmeasurement135 No Result;Turn on MCE E To calculate Timing and Phase results in the Code DomainPower view of Mod Accuracy, the "Multi Channel Estimator"must be set to ON. Otherwise these results are invalid.137 (unused)139 Uncalibrated Summary E141 Input Overload W141 Input Overload;ADCover rangeW The signal at the input to the IF section is too high. Youshould increase the attenuation or lower the signal level.141 Input Overload;I/Q ADCover rangeW The I or Q input exceeds the ADC upper limit.141 Input Overload;I/QVoltage over rangeW The input voltage on the I or Q channel exceeds thechannel limit. In differential mode the over voltage mayoccur without causing an ADC overload, for example, if I isat +5.01 V and I-bar is at +5.0 the ADC will be in range butboth I and I-bar will exceed the voltage limit.143 (unused)145 (unused)
