8EN4. Transmitter programming1 2 3 4 5 6 7 8ERRORSTOPPHOTOSTARTRADIOSET1 2 3 4 5 6 7 8ERRORSTOPPHOTOSTARTRADIOSETThe transmitters to be programmed must be of the “Stylo4K” or “Stylo2K” series byKing Gates. See adjacent pictures.If, at the start of the following procedures, the “set”, “radio” and “start” LEDs flash,it means that the programming protections have been activated – see Paragraph 16.1.To interrupt the following programming procedures at any time, press the SET andRADIO buttons simultaneously or wait 10 seconds4.1 - Start button programmingThis procedure allows for programming the button of the radio control linked to the automation’s start function.1. PRESS THE RADIO BUTTONFOR 1 SECOND2. PRESS THE DESIRED BUTTONOF ALL THE TRANSMITTERSTO BE PROGRAMMED3. PRESS THE SET AND RADIOBUTTONS SIMULTANEOUSLY ORWAIT 10 SECONDS TO EXIT THEPROCEDUREThe red “radio” LED turns on in the fixedmode (if not, consult Paragraph 16.1) The red “radio” LED flashes The red “radio” LED turns off4.2 - Pedestrian opening button programmingThis procedure allows for programming the button of the radio control linked to the automation’s partial opening. The broadness of the pe-destrian opening can be customised through the procedure described in Paragraph 5.2.1. PRESS THE RADIO BUTTONFOR 1 SECOND2. PRESS THE START BUTTONFOR 1 SECOND3. PRESS THE DESIRED BUTTONOF ALL THE TRANSMITTERSTO BE PROGRAMMEDThe red “radio” LED turns on in the fixedmode (if not, consult Paragraph 16.1)The red “radio” LED remains lit in fixed mode andthe green “start” LED turns on in fixed modeThe red “radio” LED flashes and thegreen “start” LED turns on in fixed mode4. PRESS THE SET AND RADIOBUTTONS SIMULTANEOUSLYOR WAIT 10 SECONDS TO EXITTHE PROCEDUREThe red “radio” LED and the green“start” LED turn offStart button Set buttonRadio button4“Stylo4K” “Stylo2K”