ConfigureUDS-10 User Guide 3-153.6 Channel 1 Configuration (Serial Port Parameters)Using this option, define how the serial port will respond to network and serialcommunications.Baudrate (9600)I/F Mode (4C)Flow (00)Port No (10001)ConnectMode (C0)Remote IP Address : (000).(000).(000).(000)Remote Port (00000)DisConnMode (00)FlushMode (00)DisConnTime (00:00) :SendChar 1 (00)SendChar 2 (00)3.6.1 BaudrateThe unit and attached serial device, such as a modem, must agree on a speed or baud rate touse for the serial connection. Valid baud rates are 300, 600, 1200, 2400, 4800, 9600 (default),19200, 38400, 57600, and 115200 bits per second.3.6.2 I/F (Interface) ModeThe Interface (I/F) Mode is a bit-coded byte that you enter in hexadecimal notation.Note: See Table 35 - Binary to Hexadecimal Conversion Table.Table 6 - Interface Mode OptionsI/F Mode Option 7 6 5 4 3 2 1 0RS-232C (1) 0 0RS-422/485 (1) 0 1RS-485 2-wire (1) 1 17 Bit 1 08 Bit 1 1No Parity 0 0Even Parity 1 1Odd Parity 0 11 Stop bit 0 12 Stop bit 1 1(1) The UDS-10 requires you to choose the correct setting in the IF mode.
