ConfigureUDS-10 User Guide 3-213.6.6 Remote IP AddressThis is the destination IP address used with an outgoing connection.3.6.7 Remote PortThe remote TCP port number must be set for the unit to make outgoing connections. Thisparameter defines the port number on the target host to which a connection is attempted.Note: To connect an ASCII terminal to a host using the unit for login purposes, use theremote port number 23 (Internet standard port number for Telnet services).3.6.8 DisConnModeNote: See Table 35 - Binary to Hexadecimal Conversion Table.Table 12 - Disconnect Mode OptionsDisconnect Mode Option 7 6 5 4 3 2 1 0Disconnect with DTR drop (6) 1Ignore DTR 0Telnet mode and terminaltype setup (1) 1Channel (port) password (2) 1Hard disconnect (3) 0Disable hard disconnect 1State LED off with connection(4) 1Disconnect with EOT (^D) (5) 11. The CoBox will send the "Terminal Type" upon an outgoing connection.2. A password is required for a connection to the serial port from the network.3. The TCP connection will close even if the remote site does not acknowledge the disconnection.4. When there is a network connection to or from the serial port, the state LED will turn off instead of blink.5. When Ctrl D or Hex 04 are detected, the connection is dropped. Both Telnet mode and Disconnect with EOT must be enabledfor Disconnect with EOT to function properly. Ctrl D will only be detected going from the serial port to the network.6. When DTR on the CoBox/UDS product transitions from a high state to a low state, then the network connection to or fromthe serial port will drop.
