Appendix E: Compliance InformationXPress DR+ User Guide 112XPress DR+W Regulatory InformationUSA Federal Communications Commission (FCC) NoticeThis device complies with part 15 of the FCC Rules. Operation is subject to the followingtwo conditions:This device may not cause harmful interference, andThis device must accept any interference received, including interference that may causeundesired operation.Caution: Changes or modifications to this product not expressly approved by Lantronixcould void the user's authority to operate this equipment.Note: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation.If this equipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to try tocorrect the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected. Consult the dealer or an experienced radio/TV technician for help.Caution: Exposure to Radio Frequency RadiationThe equipment contains transmitter with FCC ID: R68XSDRWLSGThe antenna(s) used for this transmitter must be installed to provide a separationdistance of at least 20 cm from all persons and must not be co-located oroperating in conjunction with any other antenna or transmitter. Installers and end-users must be provided with antenna installation instructions and transmitteroperating conditions for satisfying RF exposure compliance.Canada – Industry Canada NoticeThis device complies with Industry Canada RSS-210 regulations(IC: 3867A-XSDRWLSG). Operation is subject to the following two conditions: This device may not cause interference, and This device must accept any interference, including interference that may causeundesired operation of the device.To prevent radio interference to the licensed service, this device must be operatedindoors only and should be kept away from windows to provide maximum shielding.
