Chapter 6: Configuration Using Web ManagerXPress DR+ User Guide 58Endpoint ConfigurationLocal Port Enter the local port number.Remote Port Enter the port number of the remote device.Remote Host Enter the IP address of the remote device.Device Address Table The table is enabled when Datagram Type is set to FD. Entervalues between 1 and 255 to identify units on the localnetwork of device servers.Note: Lantronix Tech Support supports Datagram type 01.Datagram Type FD is for OEM use.3. When finished, click the OK button.4. To save and reboot, click Apply Settings on the main menu.WLAN Configuration (XPress DR+W only)Once you have initially configured the wireless unit's network and WLAN settings, youcan modify them in Web Manager. For information on initial configuration, seeChapter 4: XPress DR+W.Without adequate protection, a wireless LAN is susceptible to access by unauthorizedusers.The XPress DR+W WLAN Settings menu permits the following actions: Configuration of the wireless network profile available for activation Configuration of the wireless network security settings Configuration of advanced settings such as radio power managementNote: Due to regulations, the country-specific setting has been removed from the setupmenu and Web Manager. However, we provide a separate utility for changing theCountry/Zone setting. The utility is called SetZone and is included on the XPress DR+WCD. It is also available for download from the Lantronix web site.The syntax is SetZone []Leaving the zone blank causes the utility to report the current setting only. Following arevalid zone abbreviations. These settings are consistent with IEEE802.11b/g zones:US=United StatesCA=CanadaFR=FranceSP=SpainJP=JapanOT=Others, such as Europe (excluding France),Asia, Africa, and Australia
