Chapter 6: Configuration Using Web ManagerXPress DR+ User Guide 552. In the available fields, enter or modify the following information:Connect ProtocolProtocol From the drop-down menu, select TCP.Connect Mode: Passive ConnectionAccept Incoming Select Yes to accept incoming connections. The defaultsetting is Yes.Password Required Determines whether a password is required for an incomingpassive connection. This field is not available when apassword is set for Telnet mode. The default setting is No.Password If Password Required was set to Yes, enter the password forpassive connections.Connect Mode: Active ConnectionActive Connect Select None (default) to disable Active Connect. Otherwise,select the connection type from the drop-down list: With Any Character: Attempts to connect when anycharacter is received from the serial port. With Active Mdm Ctrl In: Accepts externalconnection requests only when themodem_control_in input is asserted. With Start Character: Attempts to connect when itreceives a specific start character from the serialport. The default start character is carriage return. Manual Connection: Attempts to connect whendirected by a command string received from theserial port. Auto Start: Automatically connects to the remoteIP address and port after booting up.Start Character If Active Connect is set to With Start Character, enter thestart character in this field. The default setting is 0D.Modem Mode Indicates the on-screen response type when in Modem Mode(if Modem Mode is enabled). The default setting is None.Endpoint ConfigurationLocal Port Enter the local port number.Auto increment foractive connectSelect to auto-increment the local port number for newoutgoing connections. The range of auto-incremented portnumbers is 50,000 to 59,999 and loops back to the beginningwhen the maximum range is reached. Disabled by default.Remote Port Enter the remote port number.Remote Host Enter the IP address of the remote device.
