Lantronix xPico WiFi User Manual

Also see for xPico WiFi: User guide

Contents

Lantronix xPico WiFi User Manual Manual pdf 28 page image

5: Line and Tunnel SettingsxPico® Wi-Fi® Embedded Device Server User Guide 28Packing ModeWith Packing, data from the serial Line is not sent over the network immediately. Instead, data isqueued and sent in segments, when either the timeout or byte threshold is reached. Packingapplies to both Accept and Connect Modes.Table 5-3 Tunnel Packing Mode SettingsTunnel Packing ModeSettingsDescriptionMode Configure the Tunnel Packing Mode. Choices are: Disable = Data not packed. Timeout = data sent after timeout occurs. Send Character = data sent when the Send Character is read on the SerialLine.Threshold Set the threshold (byte count). If the received serial data reaches thisthreshold, then the data will be sent on the network. Valid range is 100 to1450 bytes. Default is 512.Note: This configuration option becomes available when Timeout is theselected Mode.Timeout Set the timeout value, in milliseconds, after the first character is received onthe serial line, before data is sent on the network. Valid range is 1 to 30000milliseconds. Default is 1000.Note: This configuration option becomes available when Timeout is theselected Mode.Send Character Enter Control Characters in any of the following forms: J 0xA (hexadecimal) \10 (decimal)If used, the Send Character is a single printable character or a controlcharacter that, when read on the Serial Line, forces the queued data to besent on the network immediately.Note: This configuration option becomes available when Send Character isthe selected Mode.Trailing Character Enter Control Characters in any of the following forms: J 0xA (hexadecimal) \10 (decimal).If used, the Trailing Character is a single printable character or a controlcharacter that is injected into the outgoing data stream right after the SendCharacter. Disable the Trailing Character by blanking the field (setting it to).Note: This configuration option becomes available when Send Character isthe selected Mode.