Laundrylux DAWS0 SERIES Operating Manual
Also see for DAWF0 SERIES: Installation manual
                                      | |
Contents
| 
112999 - 1 www.Laundrylux.com 3Introduction __________________________The Phase 5 Coin Computer System is a fully programmable,highly sophisticated dryer control system. The manufacturerhas designed the Phase 5 coin microprocessor controller(computer) to be the most versatile and reliable coin-operatedcontrol system available.To eliminate as many moving p arts as possible, all Phase 5coin microprocessor controller (computer) programming isdone through the membrane switch on the front of the controlpanel. The program switch that puts microprocessor controller(computer) into the program mode is a single program switch.This program switch eliminates the possibility of switch failuredue to an accumulation of lint or moisture.Phase 5 Coin Microprocessor Controller(Computer) FeaturesAUTOMATIC PROGRAM REVIEWIn the program mode, the Phase 5 coin microprocessorcontroller (computer) will show all settings by one touch of thelow temperature keypad selection.PROGRAMMABLEChanges in the programs are made at the temperature keypadselection and actual programs are displayed for verification.ADJUSTABLE TIMEProgrammable from a minimum of 1 minute to a maximum of99 minutes in 1 minute increment s.COIN ACCEPTOR DENOMINATIONSValues of coin acceptors are programmable from a minimumof 1 to a maximum value of 9999 for any U.S. or foreign coindenomination.AMOUNT TO STARTProgrammable from a minimum value of 1 to a maximum valueof 9999 in increments of one.ACCUMULATIVE TIMEThis program yields a specific value of time for any coin entrymade after the “Amount To Start” has been inserted.Time For Amount To StartThis program retains the time the owner wishes to vend. Thefeature allows any additional purchase that is made to becalculated to the second. There is no calculation necessaryby the owner . The Phase 5 coin microprocessor controller(computer) calculates the vended time.ACCUMULATIVE COINThis program selection requires that a specific value of coin(s)be inserted for additional time, programmable for any minimumamount.COIN COUNTThe number of coins inserted, including a sep arate displayprogram for optional dual coin acceptors, can be viewedthrough the Phase 5 computer ’s L.E.D. display.BAD COIN LOCKOUTEach coin is monitored. Should someone t amper with thecoin acceptor or attempt to insert a foreign object, themicroprocessor controller (computer) will “LOCKOUT” and willnot accept any entries until the reset time has elap sed(approximately 15-seconds). Once the reset time has expired,the microprocessor controller (computer) will automaticallyreset itself for the next coin entry.TEMPERATURE CONVERSIONWhen the temperature conversion status is changed (i.e. from°F to °C), the Phase 5 coin microprocessor controller(computer) will automatically convert all temperature relatedprograms/parameters from Fahrenheit to Celsius and viceversa. The Phase 5 coin microprocessor controller (computer)will perform this conversion within 1° F (2° C). The programsaffected are:1. Temperature Display Mode2. Temperature Selections3. Cool Down TemperaturesDRYING TEMPERATURESAny of the three temperature selections (HI/LO/PP) areprogrammable from a minimum of 100° F to a maximum of190° F in ten-degree increments or from a minimum of 38° Cto a maximum of 88° C in five-degree incrementt. Actualtemperature programs are displayed at time of programmingfor verification. Do not program temperature above 150° F (65° C)COOL DOWN TIMEAll three temperature selections are programmable from aminimum of 0 minutes to a maximum of 9 minutes in 1 minuteincrements.COOL DOWN TEMPERATURESIn the automatic or free dry modes, the cool down cycletermination is programmable from a minimum of 70° F to amaximum of 190° F in ten-degree increment s or from aminimum of 21° C to a maximum of 88° C in five-degreeincrements. Do not program temperature above 150° F (65° C)AUTOMATIC MODE (Patent No. 4,827,627)This program selection uses a patented Auto-Dry cycle. Themicroprocessor controller (computer) will calculate the percentof the dryness and read “donE” when complete.The Phase 5coin microprocessor controller (computer) can be programmedto have a maximum time for the “Auto Mode.” The AutomaticCycle (mode) can be used in either the “Free Dry” Mode orthe “Coin” Mode. |
Related manuals for Laundrylux DAWF0 SERIES
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine