Lumel P20 User Manual

Also see for P20: User Manual & Quick Start

Contents

10Fig. 4. Configuration of the connection with the P20 transducer.5.1. Transducer configuration by meansof the eCon softwareThe eCon software is destined for the P20 transducer configuration.One must connect the PC computer through the PD14 programmer andconfigure the connection choosing Communication -> Serial port fromthe menu (for the P20 transducer, we choose the address 1, baud rate9600 kb/s, the mode RTU 8N2 and the appropriate port COM underwhich the controller of the PD14 programmer has been installed).After configuring the connection, use the Connect button.The eCon software will automatically identify the device and con-nect to it and display all parameters in the panel P20- Configuration.To change parameters, enter the new value in the parameter windowand click the Save button.