722.5414. INSTALLATION4.1. Fitting wayP20 transducers are designed to be mounted on a 35 mm rail accor-ding to EN 60715.Housing dimensions are: 22.5 x 120 x 100 mm.On the transducer outside, there are screw or self-locking terminal strips,which make possible the connection of external wires with a 2.5 mm2cross-section (supply and output) and up to 1.5 mm2 (input).Connector of the PD14 programmerFig. 1. Overall dimensions and fitting way of the transducerTransdusers should be mounted on the rail in direct contact with an-other devices that emit heat (eg transducer P20). You must keep a mini-mum 5 mm distance between the devices to allow emit heat from thehousings to the ambient. Otherwise, the in rated operating temperatureof transducer which is in direct contact with the other transducer mayexceed the rated operating temperature stated operating conditions.