Magellan RoadMate 9250T-LMB User Manual

Contents

Setting the Map OptionsHow your map is displayed can be customizedin Settings to your preferences.1. From the Map screen, tap the MENUbutton.2. Tap the Settings Icon.3. Tap Map button.4. Use the Map Options screen to customizewhat and how your map is to bedisplayed.Setting the Map Modes (2D or 3D)The map is normally displayed in 3D mode(perspective view) but you can set the map to2D mode (top down view) if so desired.1. From the Map screen, tap anywhere onthe map. Additional controls appear.2. Tap 2D to switch the map to 2D modefrom 3D mode, or tap 3D to switch themap to 3D mode from 2D mode.3. Tap .Setting Zoom LevelsSelect the zoom level that best suits yourneeds. Note that zoom levels are limited in 3Dmode. As you zoom out in 3D, the display willswitch to 2D at higher zoom levels.1. Tap the ‘+’ or ‘-’ zoom level buttons atthe bottom of the Map screen to set thedesired zoom level.Panning on the Map1. While viewing the Map screen, slide yourfinger or a stylus across the map.2. The map screen changes to Pan mode.3. When finished, tap and the mapreturns to your current position.Routing to a Panned Position1. Pan the map until the location you wishto route to is displayed.2. Tap on the map at the point you want togo to. A red push pin will be displayedalong with information about the pointchosen at the top of the screen.3. Tap the GO button in the top left corner.4. If an active route already exists, you willneed to define what to do with this newroute point:Replace Destination: the next destinationis cleared and replaced with the oneselected from the Pan screen.Go There Now: the selected location isinserted in the route as an intermediatedestination before the next destination.