Magnavox 55MV314X Owner's Manual

Also see for 32MV304 F7: Quick start guide

Magnavox 55MV314X Owner's Manual Manual pdf 30 page image

Installation1 Press Z (Home) and use H I J K to select Setup then pressOK.2 Use H I to select Installation, then press OK.FeaturesSoundPictureSoftwareInstallationUSBReset AV settingsNetwork settings aLocationAutoprogramEnglishRestore default settingsNetworkPreferencesChannelsLanguage3 Adjust the following items.Language1 Use H I to select Language, then press OK.SoftwareFeaturesSoundPictureInstallationUSBRestore default settingsNetworkPreferencesChannelsLanguageEspañolFrançaisEnglish2 Use H I to select English, Español or Français, then press OK.Note(s)● If you need the English menu instead of the Spanish or French menu’s, press Z (Home).Use H I J K to select Configuración or Configuration, then press OK.Use H I to select Instalación or Installation, then press OK.Use H I to select Idioma or Langue, then press OK.Use H I to select English, then press OK.Press Z (Home) to exit the Home menu.Channel installationBe sure the RF cable is correctly connected to this Unit and you areregistered with your Cable TV provider when you Install Cable channels.AutoprogramIf you switch wires (e.g. between antenna and CATV) or if you move theunit to a different area after the initial setting, or if you restore the DTVchannels you deleted, it is recommended to use AutoProgram to performa new channel search.You need to select the signal type in Installation mode before youperform AutoProgram.1 Use H I to Select Channels, then press OK.2 Use H I to Select Autoprogram, then press OK.● If you run Autoprogram when you have Locked Channels, aMessage appears asking to enter your PIN. Enter your PIN in orderto Complete the Installation. You need to set the Channel Lockagain after the Installation.If Pin is forgotten go to Change PIN. L p. 293 Press OK to Select Start now.● When the Scanning and Memorizing of Available Channels isCompleted, the Lowest Memorized Channel will be Displayed.4 Follow the On-screen Instructions to Complete the Installation.00Stopcomplete.Auto programming may take more than 20 minutes toAnalog channels found:Digital channels found:System searching. Please wait...Note(s)● After setting Autoprogram, using CH + / – skips unavailable channels automatically.● If you are not receiving a signal from your Cable service, contact the Cable provider.● If you press B or OK during Autoprogram, the setup of TV channels will be cancelled.● Even if Autoprogram is completed, the channel setting will be lost if the AC power cordis unplugged before the unit goes into Standby mode by pressing B.● The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock.L p. 28● If you want to change your PIN code, follow the instruction for Change PIN. L p. 2930 .EnglishContinued on next page.