Stand Assembly123× 4Attaching the BaseYou must attach the base to the Unit to have it as a table top Unit.Be sure the front and rear of the base match the proper direction. Forlarge screen TVs, at least 2 people are required for these steps.12× 4Note(s)● Make sure to use a table to put the TV on which can support the weight of this Unit andis larger than this Unit.● Make sure the table is in a stable location and has all legs touching the floor without anytilting or rocking of the table.● When attaching the base, ensure that “FRONT” with an “arrow”, written on the bottomof the base, is downward.● When attaching the base, ensure that All Screws are tightly fastened. If the base is notproperly attached, it could cause the Unit to fall, resulting in injuries as well as damage tothe Unit.● To remove the base from this Unit, unscrew the Phillips head screws by reversing theprocedure. Be careful not to drop the base when you remove it.Installing the Remote Control Batteries1 Slide the battery cover off the back of the Remote Control.2 Insert the 2 Supplied Batteries (AAA, 1.5V). Be sure the + and –ends of the Batteries line up with the markings inside the case.3 Slide the cover back into position.Note(s)● Remove the Batteries if not using the Remote Control for an extended period of time.9 .EnglishContinued on next page.