Makita DLS714 Instruction Manual

Also see for DLS714: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

13ENGLISHPARTS DESCRIPTION[Fig.1]1 Lock-off button 2 Switch trigger 3 Blade case 4 Adjusting screw (forlower limit position)5 Adjusting bolt (for maxi-mum cutting capacity)6 Stopper arm 7 Dust bag 8 Bevel scale9 Blade guard 10 Vertical vice 11 Guide fence 12 Holder13 Lock lever (for turn base) 14 Grip (for turn base) 15 Adjusting bolt (for turnbase)16 Kerf board17 Pointer (for miter angle) 18 Turn base - - - -[Fig.2]19 Slide pole (upper) 20 Thumb screw (for lock-ing upper slide pole)21 Hex wrench 22 Clamp screw (for lockingholder)23 Lever (for bevel angleadjustment)24 Slide pole (lower) 25 Thumb screw (for lock-ing lower slide pole)- -INSTALLATIONBench mountingWARNING: Ensure that the tool does notmove on the supporting surface. Movement of themiter saw on the supporting surface while cutting mayresult in loss of control and serious personal injury.1. Fix the base to a level and stable surface, screw-ing with two bolts. This helps to prevent from tipping andpossible injury.[Fig.3: 1. Bolt]2. Turn the adjusting bolt clockwise or counterclock-wise so that it comes into a contact with the floor sur-face to keep the tool stable.[Fig.4: 1. Adjusting bolt]FUNCTIONALDESCRIPTIONWARNING: Always be sure that the tool isswitched off and the battery cartridge is removedbefore adjusting or checking the functions onthe tool. Failure to switch off and remove the batterycartridge may result in serious personal injury fromaccidental start-up.Installing or removing batterycartridgeCAUTION: Always switch off the tool beforeinstalling or removing of the battery cartridge.CAUTION: Hold the tool and the battery car-tridge firmly when installing or removing batterycartridge. Failure to hold the tool and the batterycartridge firmly may cause them to slip off your handsand result in damage to the tool and battery cartridgeand a personal injury.[Fig.5: 1. Red indicator 2. Button 3. Batterycartridge]To remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert it all the way until it locks in placewith a little click. If you can see the red indicator on theupper side of the button, it is not locked completely.CAUTION: Always install the battery cartridgefully until the red indicator cannot be seen. If not,it may accidentally fall out of the tool, causing injury toyou or someone around you.CAUTION: Do not install the battery cartridgeforcibly. If the cartridge does not slide in easily, it isnot being inserted correctly.NOTE: The tool does not work with only one batterycartridge.Tool / battery protection systemThe tool is equipped with a tool/battery protectionsystem. This system automatically cuts off power tothe motor to extend tool and battery life. The tool willautomatically stop during operation if the tool or batteryis placed under one of the following conditions. In someconditions, the indicators light up.

/ 164

Related manuals for Makita DLS714

Makita DLS714 Instruction Manual

This manual is suitable for:

DLS714

manualsdatabase

Your AI-powered manual search engine