Makita DLS714 Instruction Manual

Also see for DLS714: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

12 ENGLISHAdjusting the miter angle123 45Ź 1. Turn base 2. Pointer 3. Miter scale 4. Lock lever5. Grip1. Loosen the grip counterclockwise.2. Press down and hold the lock lever, and adjust theangle of the turn base. Use the pointer and the miterscale as a guide.3. Tighten the grip clockwise irmly.CAUTION: After changing the miter angle,always secure the turn base by tightening the gripirmly.NOTICE: When turning the turn base, be sure toraise the handle fully.Adjusting the bevel angleTo adjust the bevel angle, loosen the lever at the rear ofthe tool counterclockwise.12Ź 1. Lever 2. Release buttonTo tilt the blade to the left, hold the handle and tilt thecarriage. Use the bevel scale and the pointer as aguide. Then tighten the lever clockwise irmly to securethe arm.123Ź 1. Pointer 2. Bevel scale 3. ArmTo tilt the blade to the right, hold the handle and tilt thecarriage to the left slightly, and push the release button.With the release button pressed, tilt the saw blade tothe right. Then tighten the lever.CAUTION: After changing the bevel angle,always secure the arm by tightening the leverclockwise.NOTICE: When tilting the saw blade be sure thehandle is fully raised.NOTICE: When changing bevel angles, besure to position the kerf boards appropriatelyas explained in the "Positioning kerf boards"section.Adjusting the lever positionIf the lever does not provide full tightening in course oftime, change the position of the lever. The lever can berepositioned at every 30° angle.Loosen and remove the screw that secures the lever.Remove the lever and install it again so that it pointsslightly above the horizontal. Then, tighten the leverwith the screw irmly.21Ź 1. Lever 2. Screw

/ 24

Related manuals for Makita DLS714

Makita DLS714 Instruction Manual

This manual is suitable for:

DLS714

manualsdatabase

Your AI-powered manual search engine