Makita DLS714 Instruction Manual

Also see for DLS714: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

7 ENGLISHINSTALLATIONBench mountingWARNING: Ensure that the tool does notmove on the supporting surface. Movement of themiter saw on the supporting surface while cutting mayresult in loss of control and serious personal injury.1. Fix the base to a level and stable surface, screw-ing with two bolts. This helps to prevent from tipping andpossible injury.11Ź 1. Bolt2. Turn the adjusting bolt clockwise or counterclock -wise so that it comes into a contact with the loor sur -face to keep the tool stable.1Ź 1. Adjusting boltFUNCTIONALDESCRIPTIONWARNING: Always be sure that the tool isswitched off and the battery cartridge is removedbefore adjusting or checking the functions onthe tool. Failure to switch off and remove the batterycartridge may result in serious personal injury fromaccidental start-up.Installing or removing batterycartridgeCAUTION: Always switch off the tool beforeinstalling or removing of the battery cartridge.CAUTION: Hold the tool and the battery car-tridge irmly when installing or removing batterycartridge. Failure to hold the tool and the batterycartridge irmly may cause them to slip off your handsand result in damage to the tool and battery cartridgeand a personal injury.22 13Ź 1. Red indicator 2. Button 3. Battery cartridgeTo remove the battery cartridge, slide it from the toolwhile sliding the button on the front of the cartridge.To install the battery cartridge, align the tongue on thebattery cartridge with the groove in the housing and slipit into place. Insert it all the way until it locks in placewith a little click. If you can see the red indicator on theupper side of the button, it is not locked completely.CAUTION: Always install the battery cartridgefully until the red indicator cannot be seen. If not,it may accidentally fall out of the tool, causing injur y toyou or someone around you.CAUTION: Do not install the battery cartridgeforcibly. If the cartridge does not slide in easily, it isnot being inserted correctly.NOTE: The tool does not work with only one batterycartridge.Tool / battery protection systemThe tool is equipped with a tool/battery protection sys-tem. This system automatically cuts off power to themotor to extend tool and battery life. The tool will auto-matically stop during operation if the tool or battery isplaced under one of the following conditions:Overload protectionWhen the tool is operated in a manner that causes it todraw an abnormally high current, the tool automaticallystops without any indication. In this situation, turn thetool off and stop the application that caused the tool tobecome overloaded. Then turn the tool on to restart.

/ 24

Related manuals for Makita DLS714

Makita DLS714 Instruction Manual

This manual is suitable for:

DLS714

manualsdatabase

Your AI-powered manual search engine