Makita DUR190U Instruction Manual

Also see for DUR190L: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

24 ENGLISHReplace the nylon cord if it is not fed any more. Themethod of replacing the nylon cord varies depending onthe type of the nylon cutting head.95-M10L► Fig.4096-M10L► Fig.41Replacing the plastic bladeReplace the plastic blade if it is worn out or broken.► Fig.42When installing the plastic blade, align the direction ofthe arrow on the blade with that of the protector.► Fig.43: 1. Arrow on the protector 2. Arrow on thebladeTROUBLESHOOTINGBefore asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,do not attempt to dismantle the tool. Instead, ask Makita Authorized Service Centers, always using Makita replace-ment parts for repairs.State of abnormality Probable cause (malfunction) RemedyMotor does not run. Battery cartridge is not installed. Install the battery cartridge.Battery problem (under voltage) Recharge the battery. If recharging is not effective,replace battery.The drive system does not workcorrectly.Ask your local authorized service center for repair.Motor stops running after a little use. Battery's charge level is low. Recharge the battery. If recharging is not effective,replace battery.Overheating. Stop using of tool to allow it to cool down.It does not reach maximum RPM. Battery is installed improperly. Install the battery cartridge as described in thismanual.Battery power is dropping. Recharge the battery. If recharging is not effective,replace battery.The drive system does not workcorrectly.Ask your local authorized service center for repair.Cutting tool does not rotate:stop the machine immediately!Foreign object such as a branch isjammed between the guard and thecutting tool.Remove the foreign object.The drive system does not workcorrectly.Ask your local authorized service center for repair.Abnormal vibration:stop the machine immediately!One end of the nylon cord has beenbroken.Tap the nylon cutting head against the ground whileit is rotating to cause the cord to feed.The drive system does not workcorrectly.Ask your local authorized service center for repair.Cutting tool and motor cannot stop:Remove the battery immediately!Electric or electronic malfunction. Remove the battery and ask your local authorizedservice center for repair.OPTIONALACCESSORIESWARNING: Only use the recommendedaccessories or attachments indicated in this man-ual. The use of any other accessory or attachmentmay result in serious personal injury.CAUTION: These accessories or attachmentsare recommended for use with your Makita toolspecified in this manual. The use of any otheraccessories or attachments might present a risk ofinjury to persons. Only use accessory or attachmentfor its stated purpose.If you need any assistance for more details regard-ing these accessories, ask your local Makita ServiceCenter.• Cutter blade• Nylon cutting head• Nylon cord (cutting line)• Plastic blade• Makita genuine battery and chargerNOTE: Some items in the list may be included in thetool package as standard accessories. They maydiffer from country to country.