Makita EY2650H Instruction Manual

Also see for EY2650H: Original instruction manual Original instruction manual Original instruction manual Owner's and safety manual Original instruction manual

Contents

16At times, such as winter, when starting the engineis difficultOperate choke lever with the following procedure when starting engine.After implementing startup steps 1) to 3), set choke lever to the CLOSE•position.Implement startup step 4) and start engine.•Once engine starts, set choke lever to the OPEN position.•Implement startup step 5) and complete warm up.•CAUTION: If a bang (explosive sound) is heard and the engine stops, or thejust-started engine stalls before the choke lever is operated, returnthe choke lever to the OPEN position, and pull the starter knob afew times again to start the engine.CAUTION: If the choke lever is left in the CLOSE position, and the starter knobmerely pulled repeatedly, too much fuel will be sucked in, and theengine will become difficult to start.OPENCLOSEADJUSTMENT OF LOW-SPEED ROTATION (IDLING)When it is necessary to adjust the low-speed rotation (idling), perform it by the carburetor adjusting screw (A).CHECKUP OF LOW-SPEED ROTATIONSet the low-speed rotation to 3,000 min- -1 .If it is necessary to change the rotation speed, regulate the adjusting screw,with Phillips screwdriver.Turn the adjusting screw to the right, and the engine rotation will increase.-Turn the adjusting screw to the left, and the engine rotation will drop.The carburetor is generally adjusted before shipment. If it is necessary to-readjust it, please contact Authorized Service Center.ASTOPPING1) Release the throttle lever (B) fully, and when the engine rpm has lowered,set the I-O switch (A) to STOP the engine will now stop.2) Be aware that the attachment may not stop immediately and allow it to slowdown fully.STOPABCaution during operation:If the throttle lever is opened fully in a no-load operation, the engine rotation is increased to 10,000 min -1 or more. Never operate the engine at ahigher speed than required and at an approximate speed of 6,000 - 8,500 min -1 .B: Startup after warm-up operation1) Push the primer pump repeatedly.2) Keep the throttle lever at the idling position.3) Pull the recoil starter strongly.4) If it is difficult to start the engine, open the throttle by about 1/3.Pay attention to the attachment which may rotate.