Maintenance Section 440 Part Number 000007345 2/14Parts Removal for Cleaning/SanitizingSingle Evaporator Ice MachinesA. Remove the water curtain• Gently flex the curtain in the center and remove itfrom the right side.• Slide the left pin out.B. Remove the water trough• Depress tabs on right and left side of the watertrough.• Allow front of water trough to drop as you pull forwardto disengage the rear pins.C. Remove the water level probe• Pull the water level probe straight down todisengage.• Lower the water level probe until the wiring connectoris visible.• Disconnect the wire lead from the water level probe.• Remove the water level probe from the ice machine.D. Remove the ice thickness probe• Compress the hinge pin on the top of the icethickness probe.• Pivot the ice thickness probe to disengage one pinthen the other. The ice thickness probe can becleaned at this point without complete removal. Ifcomplete removal is desired, disconnect the icethickness control wiring from the control board.E. Remove the water distribution tubeNOTE: Distribution tube thumbscrews are retained toprevent loss. Loosen thumbscrews but do not pullthumbscrews out of distribution tube.• Loosen the two outer screws (do not remove screwscompletely they are retained to prevent loss) and pullforward on the distribution tube to release from slipjoint.• Disassemble distribution tube by loosening the two(2) middle thumbscrews and dividing the distributiontube into two pieces.• Proceed to Page 39 Step 6O f fO n / O f f M o d e[ ]!A BCED