9-130 2x20 Customer Display InterfaceCursor Position (10h, POSITION)This command sets the cursor position. The POSITION byte moves the cursor positionaccording to the table below. The next character byte writes to the new position and thecursor auto-increments to the next position. This command is ignored if the POSITIONbyte value is greater than 27h.This command resets the module to the following conditions:1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 201 00h 01h 02h 03h 04h 05h 06h 07h 08h 09h 0Ah 0Bh 0Ch 0Dh 0Eh 0Fh 10h 11h 12h 13h2 14h 15h 16h 17h 18h 19h 1Ah 1Bh 1Ch 1Dh 1Eh 1Fh 20h 21h 22h 23h 24h 25h 26h 27hReset (13h)• 100% luminance• All 5x8 dot matrix characters set to 20h (space)• Cursor position set to 00h• Character table set to Table 1• All user defined characters cleared
