NEC EXPRESS5800 N8800-096F User Manual

Also see for NEC Express5800 Series: User guide User guide User guide User guide Configuration guide

Contents

NEC EXPRESS5800 N8800-096F User Manual Manual pdf 116 page image

6-4 TroubleshootingNote: HDD : Hard disk (SystemDrive, SystemRoot only)FD : Floppy diskCD : CD-ROMPreparationYou need a support disk, “Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER” to start upthe Recovery Console. Have “Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER” readybefore starting the Recovery Console.If you do not have a computer that runs Windows Server 2003 or Windows 2000/XP/NT.Follow the steps below to create a “Windows Server 2003 OEM-DISK for NECEXPRESSBUILDER”:1. Prepare a 3.5-inch floppy disk.2. Power on the peripherals and then NEC Express5800/ft series.3. Disable the configuration for boot monitoring function.In the BIOS setup, select [Server] - [Monitoring Configuration] - [Boot Monitoring] andchoose “Disabled.” See “Step 3: Disable Boot Monitoring Function” (page 4-9) for details.4. Insert the NEC EXPRESSBUILDER CD-ROM into the drive of the server.5. Then, reset (pressing Ctrl + Alt + Delete) or power off/on NEC Express5800/ft series toreboot it.The system will start up from the CD-ROM to start NEC EXPRESSBUILDER.6. From the [Tools] menu, select [Create Support Disk].7. From the [Create Support Disk] menu, select [Windows Server 2003 OEM-DISK for NECEXPRESSBUILDER].8. Follow the instructions on the screen to insert the floppy disk.“Windows Server 2003 OEM-DISK for NEC EXPRESSBUILDER” will be created on thefloppy disk. Write-protect and place a label on the disk and keep it in a safe place.IMPORTANT:Enable the configuration for boot monitoring function to deploy the system without performing thesystem repair which uses the Recovery Console. In the BIOS setup, select [Server] - [MonitoringConfiguration] - [Boot Monitoring] and set appropriate time. See “Step 11: Enable Boot MonitoringFunction” (page 4-35) for details.