NEC EXPRESS5800 N8800-096F User Manual

Also see for NEC Express5800 Series: User guide User guide User guide User guide Configuration guide

Contents

NEC EXPRESS5800 N8800-096F User Manual Manual pdf 49 page image

Installing Server 3-7ConnectionConnect peripheral devices to NEC Express5800/ft series.The server is provided with connectors for wide variety of peripheral devices on its front and rear.The figure on the next page illustrates available peripheral devices for the server in the standardconfiguration, and locations of the connectors for the devices. After connecting the peripheraldevices, connect the provided power cords with the server, and then plug the power cords into thepower outlet.WARNINGObserve the following precautions to use the server safely. There is a risk of adeath or serious injury. For details, see “Notes for Safe Handling” in Chapter 1. Do not hold the power plug with a wet hand. Do not connect the ground wire to a gas pipe.CAUTIONObserve the following precautions instructions to use the equipment safely.There is a risk of a burn, personal injury, or damage to physical assets. Fordetails, see “Notes for Safe Handling” in Chapter 1. Do not plug the power cord in a nonconforming outlet. Do not plug too many cords in a single outlet. Do not plug the cord insecurely. Do not use nonconforming power cords.IMPORTANT: Power off the server before connecting peripheral devices, with the exception ofperipherals with USB interface. Connecting a powered peripheral device to the poweredserver will cause malfunctions and failures. To connect a third-party peripheral device or interface cable to the server, check withyour sales agent to see if they are compatible with NEC Express5800/ft series. Somethird-party devices may not be used with the server. The total cable length of SCSI device connections is up to 6 m, including the internalSCSI cables. The serial port connectors are reserved for maintenance. Place the USB floppy disk drive on the server. Space of 1U is needed to put it on theserver.