Elite IPK Document Revision 1Programming Manual 2 - 89______________________________________________________________________________________________________________________________________________________________________1-1-78 Caller ID Display Assignment forSystem ModeGeneral DescriptionUse this Memory Block to assign up to 15 Multiline Terminals to display ANI/Caller IDIndication for normal incoming CO/PBX calls or CO/PBX calls ringing a Call Arrival(CAR) key.Display Notes Programming Procedures1 Go off-line.2 Press LK1 + LK1 + GH to access the Memory Block.3 Use the dial pad to enter Entry No. 01 and Tel Port No. Use the following to enter data:J to move the cursor leftL to move the cursor rightK~I to enter numeric dataDefault ValuesNot specified4 Press G to write the data and advance to the next Entry No. After each tel port No. is selected, press G again. Atotal of 15 entries can be made. After the last data is entered, the next Memory Block is displayed.5 Program the next Memory Block or press E to go back on-line.1. To display ANI/Caller ID Indication for normal incoming and CAR incoming calls, Caller ID Indication and RingAssignment must be programmed.2. Fifteen Multiline Terminals can be assigned system-wide to display ANI/Caller ID.3. A sixteenth terminal can be assigned to display ANI/Caller ID using another Memory Block.System Mode1Submode1Data No.78PC Programming¦+AI7 8 : C A L L I D 0 1 =T I M E D I S P L A YDataNo.EntryNo.01~15TitleTel Port No.(00~99A0~A9B0~B9CO)
