2 - 534 Memory Blocks___________________________________________________________________________________Document Revison 1 Elite IPK___________________________________________________________________________________4-68 LCD Line Key – Name AssignmentGeneral DescriptionUse this Memory Block to assign a name to each LCD Line Key of the DTH/DTR-16LD-1 Telephone. Up to eight characters can be assigned.DisplayProgramming Procedures1 Go off-line.2 Press LK4 + FH to access the Memory Block.3 Use the dial pad to change Line key number or name. Use the following to enter data:J to move the cursor leftL to move the cursor rightK~It o enter Name, Line key number orTel Port No.– OR –D to go to next assigned Tel Port No.B + Ato enter A for Port Numbers 100~109.B + Bto enter B for Port Numbers 110~119.B + Cto enter C for Port Number 120.Default ValueLK01~08: C0 01~084 Press G to write the data and display the next Line key and name.5 Repeat Steps 3 and 4 for each Line key assignment. After Line key 16 isprogrammed, the next Tel Port No. is displayed. When you want to program lessthan 16 keys, after the last Line key to program, press D to go to nextassigned Tel Port No. After all Tel Ports are assigned, the next Memory Block isdisplayed.6 Program the next Memory Block or press E to go back on-line.Related ProgrammingM.B. Number Memory Block Name7-2 Telephone Type Assignment4-12 Line Key Selection for Telephone ModeCO/PBX Line Mode4Submode—Data No.68PC Programming¦+BTT0 1 / 6 8 : L K 0 1 N A M E< C O 0 1 >Tel Port(01~CO)DataNo.Line Key01~16 TitleSetting Data
