2 - 288 Memory Blocks______________________________________________________________________________________________________________________________________________________________________Document Revison 1 Elite IPK1-14-02 ARS Dial Allow/Deny SelectionGeneral DescriptionUse this Memory Block to specify whether or not to Allow digits that are entered in theARS dialing assignment to be routed using the ARS feature.DisplaySettingsLK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shadedselection is thedefault.YES NOProgramming Procedures1 Go off-line.2 Press LK1 + LK14 + KB to access the Memory Block.3 Press the corresponding CO/PBX line key to change the Setting Data option. Use the following to enter data:K~I to select dataJto move cursor leftLto move cursor right4 Press G to write the data. The next Dial No. is displayed.5 Repeat Steps 3 and 4 for each Dial No. (01~C8) for Table 1. After Dial No. C8 is programmed, the next Table No. is displayed.6 Repeat Programming cycle for each Dial No.(01~C8) for Tables 2~4. The next Memory Block is displayed.7 Program the next Memory Block or press E to go back on-line.Related ProgrammingM.B. Number Memory Block Name3-03 Trunk-to-Trunk Group Assignment4-40 LCR Class Selection1-1-30 Route Advance Block Assignment1-8-08 Class of Service (Station) Feature Selection 21-14-00 ARS Allow/Deny Selection1-14-01 ARS Dial Allow/Deny SelectionSystem Mode1Submode14Data No.02PC Programming¦+AB0 2 : 1 / 0 1 A / D Y E ST I M E D I S P L A YTableNo.1~4SettingDataDataNo.DialNo. Title
