Configuring Your Server 4-19Exiting the UtilityTo exit the utility, press Esc until a message prompts you to exit (if you changed any setting, youare prompted to save the changes before you exit).Configure/View SCSI Controller SettingsThe Configure/View Host Adapter Settings has the following menu items and parameters. Readdescriptions to select a correct parameter for each menu item.SCSI Bus Interface DefinitionsTo set three menu items under "SCSI Bus Interface Definitions", select a menu item with the cursorkeys (↓ or ↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection.The following table lists menu items, available parameters, and descriptions.Menu item Parameter DescriptionSCSI Controller ID 0 - [7] - 15 Select "7".SCSI Controller Parity [Enabled]DisabledSelect "Enabled".SCSI ControllerTermination[Enabled]DisabledEnable or disable the SCSI termination.Select "Enabled".[ ]: Factory-setAdditional OptionsTo set three menu items under "Additional Options", select a menu item with the cursor keys (↓ or↑) and press Enter to display its submenu. Then, select a submenu item with the cursor keys (↓ or↑) and press Enter to fix the item. Use the cursor keys (↓ or ↑) for parameter selection. Boot Device ConfigurationMove the cursor onto "Boot Device Configuration" and press Enter to display thesubmenu. The Boot Device Configuration submenu allows you to select the deviceconnected to the channel A or B as a boot device. Always select "AIC-7902 A".
