5-54 Installing the Operating System with Express SetupInstalling with the OEM-FD for Mass Storage DeviceThis section explains how to setup with the OEM-FD. You usually do not have to do as follows. Ifyour system has any Mass storage devices, you have to set as follows depending on your system.The detailed information is provided by the manual of the Mass storage device.Creating new RAID using N8403-026 (RAID Controller), N8403-027 (SATAInterface card)If you create new RAID using N8403-026 (RAID Controller), N8403-027 (SATA Interface card),create RAID by following procedure before installing Windows Server 2008.If you do not need to create new RAID, this procedure is not required.Case of creating RAID using [EXPRESSBUILDER].1. Boot from the EXPRESSBUILDER DVD.2. Select [Perform the Express setup] from the Top Menu, click [Next].3. When [Load parameters] screen is displayed, if you do not need to load parameters, select[Do not load parameters] and click [Next].4. Select [Install other Operating System] at [Select OS] steps, and then click [Next].5. Select [Create a logical drive using the settings that follow] at [Enter RAID settings]steps.Confirm the parameters, modify if necessary, and then click [Next].6. Save parameters at [Save parameters] steps.If you do not need to save parameters, select [Do not save parameters], and click [Next].7. Click [Perform] at [Configuring RAID] steps.RAID configuration is started.8. When [Exit EXPRESSBUILDER] screen is displayed, click [Perform] again.The system reboots.Reboot from EXPRESSBUILDER DVD, and then perform Express Setup referring to[Installing the Operating System with Express Setup].NOTE: When you start Express Setup, select [Skip the logical drivecreation] at Step 4 [Enter RAID settings] screen.
