NEC Express5800/B120a User Manual

Also see for Express5800/B120a: User guide

Contents

NEC Express5800/B120a User Manual Manual pdf 241 page image

Troubleshooting 8-19Problems with NEC EXPRESSBUILDERWhen the CPU blade is not booted from the NEC EXPRESSBUILDER DVD, check the following: Did you set the NEC EXPRESSBUILDER during POST and restart the CPU blade?→ If you do not set the NEC EXPRESSBUILDER during POST and restart the CPUblade, an error message will appear or the OS will boot. Is BIOS configuration correct?→ The boot device order may be specified with the BIOS setup utility of the CPUblade. Use the BIOS setup utility to change the boot device order to boot thesystem from the DVD-ROM drive first. [Boot]> If [Os installation ***default***] is selected at Boot selection screen, followingmessage is displayed.After this message appears, check the error and take the appropriate corrective actionaccording to the message listed in the table below.Message CauseThis EXPRESSBUILDER version was not designedfor this computer.Insert the correct version and click [OK]. (When youclick [OK], the computer reboots.)This NEC EXPRESSBUILDER version isnot designed for this server.Execute the NEC EXPRESSBUILDER onthe compliant server.EXPRESSBUILDER could not get the hardwareparameters written in this motherboard.This version is not designed for this computer or themotherboard may be broken. (When you click [OK],the computer reboots.)The hardware parameters written in thismotherboard are incorrect.This version is not designed for this computer or themotherboard may be broken.This message is shown when NECEXPRESSBUILDER could not find system-specific information because of motherboard exchange and so on.